Week 6

Title of Activity
-Continue on doing the PCB design.
-Drill the PCB board.
-Purchased the project materials.


Objective
-To apply the design on the PCB board.
-To purchased the necessary material for the project.

Content/Procedure
-The look of the circuit when apply it on the PCB board.

The design on the PCB board

 -The PCB board must be drilling to make sure all the component can be put at their place.
-The look of PCB board after drilling.

-The receipt for purchased material.

Result/Analysis
 -This the final design for the PCB board where before this I got difficulty on doing the design.
-For the material or component, not all component in the circuit are 100% the same. There is several component need to change due to some of the component cannot be found.
-Others need to be order such Atmel ATmega644p.

Conclusions
 As a conclusions, the difficulty is there several component you cannot get and some of the component are not in Malaysia in other word you need to order it. In this matter two important component are not in here the probe button for measuring that has been change with normal probe and a plug in jack for speaker with top of it a push button also change with normal plug in jack.